—
Support POE(Power over Cable) which can power both units from TX or RX with power supply.
—
HDCP & EDID Bypass
—
CEC support
—
Auto equalization
—
Pure unaltered uncompressed 7.1ch digital HDMI over Cat.5/5e/6 cable transmission
—
DTS-HD Master Audio and Dolby TrueHD high bit rate audio support
—
Support full frequency IR signal from 20KHz to 60KHz
—
Bi-directional IR path-through
—
Full Duplex RS-232 control up to 115,200 bps through connector
—
Integrated Ethernet port for LAN/ network device
—
Wall mounting housing design for easy and robust installation
*The length depends on the characteristics and quality of the cables. Higher resolutions
and longer transmission distances require low skew cables (<25ns/100m) for best
performance. Unshielded CAT6 with metal RJ-45 connectors is recommended.
1.3 Package Contents
Before you start the installation of the switch, please check the package contents.
— DC 24V in-line with C7 power cord
1.4 Panel Descriptions
FRONT PANEL — PT-E-HD50, transmitting unit (TX)
IR TX: Infrared 3.5mm socket for plugging in the extension cable of IR blaster
IR RX: Infrared 3.5mm socket for plugging in the extension cable of IR receiver
HDMI IN: Connects to a HDMI source with a HDMI male-male cable
Ethernet
LED: Power indicator
+24V DC: Connect to a 5V DC power supply.
Comments to this Manuals